WILL IT FIT? Measure from the center of the four VESA mounting holes on the back of your monitor to the edge of the monitor. If you are keeping the swiper on the POS/Monitor, then measure past the swiper. This mount will extend either 7.5" or 8.5" from the center of your monitor. There are two mounting options with this mount (7.5” or 8.5”).
Shown with PAX S300 PINpad, this is a custom bracket that brings the payment device off of the counter, and next to the POS Terminal. The bracket, made of metal with a black coating is secured between the POS stand and the terminal. The bracket cradle for the PINpad comes with two sets of screw holes to raise or lower the height of the PINpad. The mount comes with all of the mounting screws for the install. This solution is ideal for Server and Bar POS stations. The POS mount on the bracket has holes for both 70mm and 100mm VESA mounts. VESA mounts are the four screw holes that come standard on the back of a monitor/display.
Includes three sets of screws for mounting. The ones you use will depend on the thickness of your monitor stand. If no monitor stand is being used, then most likely you will use the small screw.
There are three (3x) sets of four (4x) screws:
M4 x 10mm - 4x screws - Small
M4 x 14mm - 4x screws - Medium
M4 x 18mm - 4x screws - Long
Tools needed for the install: Regular sized screwdriver, small screwdriver.
The mount can be used on the left or right side of the 15" or 17" monitor.
If you are unsure of the size of your monitor, a 17" monitor is typically 8" from the center to the side.
This mount is also available for the 19"/23" monitors and for the following PIN Pads: Ingenico Lane/3000/5000/7000/8000, IPP310/320/350, Vx805, VX820, and RP10 PIN Pads. If you want to use it with any other PINpad, there is a 25 unit minimum.
Please specify at checkout or call to tell us which PINpad mount you need.
